DRAMeXchange> Weekly Research> Elite performance: Next generation SSDs for high-end NB and professional PC...

【Performance Test】Elite performance: Next generation SSDs for high-end NB and professional PC users - Final Result

Published Mar.10 2010,18:33 PM (GMT+8)


DRAMeXchange - 1H2010 SSD compared and analyzed

A total of 40 SSD products were listed in the evaluation, mostly MLC SSDs with capacities of 64GB and 128GB. In the evaluation, we also compared the differences between SLC NAND Flash and MLC SSD, as well as the differences between SSD controllers.

Of the many products in the evaluation, we found that, although some of the SSD controllers were supplied by the same vendors, different sources of NAND Flash also results in the differences in their performance. Another factor affecting the performance is the SSD firmware itself; each individual vendor has its own method of optimizing their firmware.

Nand Flash chips used in the SSD are divided into higher priced SCL, and lower-priced MLC. The former is suitable for writing data, while the latter shows better performance in reading data; the downside of the MLC is its shorter lifespan and that it requires SSD controller to provide better algorithms to enable MLC SSD Flash chips to write data uniformly, in order to extend its service life. Theoretically, the current algorithm framework allows it to remain operational for a good few years. We will also conduct tests to address concerns such as SSD performance decline after long-term use, or re-formatting required to restore its performance.

Reading performance of MLC SSD is generally good; reading speed of 200MB~260MB per second is already one of the most important requirements of SSD products in 2010.

As for writing performance, SLC SSDs are still faster, achieving >200MB per second. However, in this 1H2010 evaluation, there are also MLC SSDs that are capable of reaching writing speed of 200MB per second.

SSD Controller ICs Key to SSD performance

In our evaluation, we found out that in the efficiency of SSD controllers, in addition to Intel and Samsung's Flash which are produced in-house, others such as SandForce, Indilinx, JMicron also performed well.

Among them, SSDs featuring SandForce chip generally do not have built-in DRAM cache. The new design enables the SSD to rival against SSDs with DRAM cache and Indilinx, JMicron controller.

Overall Evaluation of SSD

As the writing time of Flash memory chips is limited to between thousand of times to ten thousand times, many may be concerned about the lifespan of Flash memory based SSDs. Considering this fact, manufacturers have adopted the algorithm which takes account of the storage times and detritions of different areas of the chip, and have established the balanced quality subject to the written data, preventing the over-writing of specific zone of the chip.

The SSD also features data-preservation during power failure, coupled with wear leveling technology, users can be more assured of the data security.

It can be seen in all the tests that the major difference among the SSD products is in the writing and reading efficiency. First, the efficiency of different Flash chips adopted – though all are MLC NAND Flash, the performance of the chips can influence the overall SSD efficiency. Second, the controller chip adopted and the size of Cache also have an impact on the SSD efficiency.

Because SSDs give off less heat, fans are no longer required, which makes its application in desktops and notebooks quieter, and it prevents over-heating in the disk configuration. The elimination of fans also reduces noise, which is beneficial for both the application environment and the product itself.

As to the TRIM instructions of Windows 7, the supporting SSD is able to directly delete FLASH-stored data to release free block, which in turn reduces SSD block processing time, enables immediate writing into the system, and enhances writing speed. In our tests, we also found that the writing rate of new generation SSDs improved remarkably, making better progress than the reading rate.

According to our test data, many products achieved the transfer rate on their labels, confirming makers' integrity in the labeling of their products.

On the whole, 2.5 inch mainstream SSD products are suitable for commercial notebook users, as well as desktop users who require higher efficiency. However, the SSD price and mainstream storage capacity are still far from traditional hard disks on the market. For users, purchasing the combination of SSDs as the system's main hard disk/boot disk and traditional hard disks special for massive data storage may well be an effective balance between efficiency and cost.

64GB SSD evaluation – performance rankings

The 64GB category is the acceptable price range by general consumers. Of the 20 varieties of SSDs in the evaluation, we selected 10 products which excel in overall performance, specifications, and have superior product quality. The recommended products are as follows:

1, Intel X25-M SSDSA2M080G2GC 80GB

2, OCZ Agility EX 60GB SSD

3, KingFast KF251MCI 64GB SSD

4, A-Data SSD S592 64GB


6, Gingle V3 64GB SSD

7, PQI SSD S528 64GB


9, RiDATA X-series NSSD-X25-64-C07M-PN 64GB SSD

10, RunCore RCP-IV-S2564-C 64GB SSD

In this 64GB MLC SSD evaluation, we also selected top performers in each criteria, including:

Best performance/price ratio: A-Data SSD S592 64GB

Best overall transmission efficiency: OCZ Agility EX 60GB SSD

Best high-speed writing: KingFast KF251MCI 64GB SSD

Best system boot disk: Intel X25-M SSDSA2M080G2GC 80GB

Best high-load IO: CORSAIR CMFSSD-64GBG2D P64 SSD

 (PCMark 05 10%+ PCMark Vantage 40% + IOPS 10% + Throughput 40%)

128GB SSD evaluation – performance rankings

The 128GB category is the acceptable price range by gamers and enterprise users. Of the 20 varieties of SSDs in the evaluation, we selected 10 products which excel in overall performance, specifications, and have superior product quality. The capacity of these products is suitable for use as the primary hard disk, and their overall system efficiency is also quite impressive. The recommended products are as follows:

1, Intel X25-M SSDSA2M160G2GC 160GB

2, OCZ Vertex PRO 120GB SSD

3, A-Data SSD S599 100GB


5, MX-Technology MXSSD2MDS 100GB SSD

6, Micron REALSSD C300 128GB


8, Apogee Mars FlashSSD 128GB


10, SUPER Sspeed SSD 128GB

Furthermore, in this 128GB MLC SSD evaluation, we also selected top performers in each criteria, including:

Best performance/price ratio: CORSAIR CMFSSD-128GD1 X128 SSD

Best overall transmission efficiency: OCZ Vertex PRO 120GB SSD

Best high-speed writing: G.SKILL PHOENIX 100GB SSD

Best system boot disk: Intel X25-M SSDSA2M160G2GC 160GB

Best high-load IO: A-Data SSD S599 100GB


(PCMark 05 10%+ PCMark Vantage 40% + IOPS 10% + Throughput 40%) 

Insights from DRAMeXchange

The price gap of NAND flash is still quite substantial in 2010. With advancements in the manufacturing process of flash chip providers, and the increase in their output, the cost of SSD has been declining. Currently, SSD is increasingly more popular than they were in 2008 and 2009.

In terms of capacity and performance, Intel offers highly-competitive products. Additionally, Intel's NAND Flash chips are 34 nm products which are far more cost-competitive than non-Intel products. However, memory module manufacturer and brand manufacturers have also launched SSD products that rival with the Intel variants.

In terms of existing SSD controllers, semiconductor design companies such as JMicron, SandForce, and Indilinx, as well as flash chip providers, will be unveiling 3X nm NAND Flash chips in Q2 2010. Moreover, non-Intel flash chip providers will also introduce 3X-nm flash SSD controller chips. It is estimated that more SSDs that adopt 3X-nm flash chips will be launched by the end of 2010. At that time, SSD prices may decline by about 20%. As for Intel, the company will still offer 25-nm products in 2011, which are expected to further reduce SSD costs by about 20%, taking the SSD competition in 2011 to new heights.

As for the overall market, more affordable SSD prices and higher consumer acceptance are spurring the overall development of the SSD industry, and providing broader export channel for NAND Flash vendors' newly established capacity.

Furthermore, with significant enhancement in performance and capacity, SSD can be used to replace the primary hard drive in high-end laptops, it is also well suited for multimedia-editing purposes, as well as the system's primary hard drive, all of which are possible applications for SSDs in the future.

Stay tuned for the SSD controller comparison report.